Advertisement
13. Align the CAD over the mounting holes,
and re-install the factory bolt from step #10 in
the radiator support. Slide the grommet for-
ward into the hole in the CAD as shown.
16. Install the urethane hump hose (#5) onto
the back side of the CAD tube using two #72
hose clamps (#17). Tighten only the hose clamp
on the metal tube for now.
A.
19. A.) Install the large end of the Airaid
Intake Tube into the hump hose.
B.) Now slide the small end into the reducer
on the throttle body.
22. Install the Airaid Premium Filter (#1)
onto the CAD tube and tighten the hose
clamp. Next, install the weather strip (#7)
onto the top of the CAD as shown, starting
at the fender, working your way towards the
radiator.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions
that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are
missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION
IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
Don't Forget Your
AIRAID Filter
Tune-Up Kit!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
14. Re-install the factory bolt from step # 8
thru the CAD, and into the fender. Re-install
the fuse box on the factory mount.
17. Install the reducer (#6) onto the throttle
body using two #44 hose clamps (#16). Tighten
only the hose clamp on the throttle body for
now..
B.
20. Install the 6mm bolt (#15), and 1/4" flat
washer (#12), thru the L-bracket, and into the
valve cover, adjust for fit, and then tighten all
hose clamps, and bolts.
23. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Periodically
check the tightness of all hose clamps, nuts,
and bolts.
24. Reconnect the negative battery
cable!
Included with your Airaid Intake System is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Before!
AiraidInfo@airaid.com
15. Install the supplied 1/4"button head bolt
(#11), and 1/4" washer (#12), thru the CAD,
with the 1/4" fender washer (#13) and nut
(#14), on the bottom of the fender. Re-install
the factory bolt in the radiator shroud re-
moved in step #9.
18.
Install the L-bracket (#18), onto the
Airaid Intake Tube (#4), using one 1/4" but-
ton head bolt (#11), and flat washer (#12).
Leave the bolt loose for now.
21.
Re-connect the breather hose to the
Airaid Intake Tube.
After!
Instructions Revision
Date: 06/19/07
www.airaid.com
Advertisement
