Airaid 310-164 Installation Instructions

1. Disconnect the negative battery cable.
Loosen the hose clamp that holds the factory
intake tube to the resonator.
4. Disconnect the breather hose from the reso-
nator.
7. Remove three bolts from inside the lower air
cleaner box and remove it from the vehicle.
10. Remove and save the bolt from the pas-
senger side radiator support brace. It will be
re-used in step #13.
2. Unlatch the clips on the factory air cleaner
lid, next remove the lid, and tube as an assem-
bly.
5. Remove the bolt that holds the resonator to
the valve cover.
B.
8. A.) On the right fender, pry two tabs away
from the fuse box, lift it up and set it off to the
side. B.) Next, remove and save the outside bolt
from the fuse box mount. It will be re-used in
step #14.
11. Assemble the two Cool Air Dam panels (#2)
& (#3) using the four 6-32 screws (#8), #6 flat
washers (#9), and nuts (#10), as shown.
Installation Instructions
Part Number 310-164
1997-2002 Jeep Wrangler (TJ)
2.5L I-4
#1 700-456
#2 KIT158MAFC
#3 KIT158BPC
#4 KIT164T
#5 KITHUMPHS09
#6 KITRDCR03
#7 KITWSTRIP02
KIT164HP
#8 KIT6C31MXPPZ
#9 KIT6NWSAPZ
#10 KIT6CNKEPZ
#11 KIT15DHC3050
#12 KIT09FWX019
#13 KIT09FEZ025125
#14 KIT25CNNES
#15 KIT60C120HCS
#16 KITHS44
#17 KITHS72
#18 KIT164B
#19 KITGRMT05
Tools Required For Installation:
3. Loosen the clamp that holds the resonator to
the throttle body.
6. Remove the resonator from the vehicle.
A.
9. Remove one bolt from the passenger side
radiator fan shroud and save it for step #15.
12. Slide the rubber grommet (#19) over the
radiator support, followed by the assembled
CAD. Use caution not to scratch the paint on
the support rod.
Packing List:
Airaid Premium Filter
MAF Panel
Bottom Panel
Airaid Intake Tube
Urethane Hump Hose
Reducer
Weather Strip 27"
Hardware & Instructions 1
6-32x5/16" Screw
#6 Flat Washer
6-32 Keps Nut
¼ - 20x1/2" Button Head Bolt
¼" Flat Washer
1/4" Fender Washer
1/4-20 Nylock Nut
M6x12mm Hex Bolt
#44 Hose Clamp
#72 Hose Clamp
L-Bracket
Grommet
5/32" Allen Wrench
5/16" & 7/16" Sockets
10mm & 13mm Sockets
Ratchet & Extension
Phillips Screwdriver
1
1
1
1
1
1
1
4
4
4
2
3
1
1
1
2
2
1
1