Kolpin 93450 Installation Instructions

Please read and understand these instructions completely before installation to avoid injury to yourself or damage to the vehicle
or accessory.
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation.
Parts List:
ITEM PART NAME
1
Box
2 U-Bolt
3 U-Bolt Plate
4
Washer
5 Washer
6 Nut
7
Thread Cap
Please Note: The Outfitter Box was designed to fit most ATV rack
systems. These particular instructions demonstrate mounting this
accessory on a tubular-type rack system. Because rack systems may
vary in size and design, use your best judgement in determining
where to locate the mounting hardware in order to provide a secure and
stable installation.
1) Position your Outfitter Box on the rear rack of your vehicle in your
desired location and center as indicated in Image "A".
2) Once you have the Outfitter Box positioned properly, use a pencil to
mark two mounting points. Do this by scribing a line at these locations
on each side of the rack as indicated in Image "B".
3) After you have marked the two mounting locations, remove the
Outfitter Box and carefully lay it upside-down on a level surface.
Center one of the supplied U-bolt plates on the lines you have just
marked. Using the U-bolt plate as a template, mark the two hole
locations with a pencil as indicated in Image "C". Repeat this step.
Outfitter Box Installation Instructions
Stock No.: 93450
PART NO.
100-93450 Outfitter Box assembly
72-0001 1/4" x 1-1/8" x 2" U-bolt, zinc-plated
72-0002 2" x 3/4" U-bolt plate, zinc-plated
76-0035 1/4" bonded sealing washer, zinc-plated
76-0041 1/4" lock washer, zinc-plated
77-0017 1/4"-20 finish nut, zinc plated
56-0008 Black thread caps
Outfitter Box
Underside
of Your Rack
DESCRIPTION (60-93450)
Image B
Rear of
Vehicle
Underside
of Outfitter
Box
Center
QTY.
1
2
2
4
4
4
4
Image A
Image C