Single Distance Measurement; Continuous Measurement - Agatec AgaTape Manual

• To measure out of a corner (see drawing {D}),
fold out the stop bracket until it snaps in, push
the stop bracket with a little force to the right
side; the stop bracket can now be completely
unfolded. See drawing {E}.
CAUTION:
Make sure that when measuring from the
unfolded endpiece, the measuring reference is set to
"End piece"!
1x briefly: the next measurement is taken from
the front edge.
2x briefly: the measurement is taken from the
unfolded end piece.
After one measurement, the reference returns auto-
matically to the default setting (rear reference).
1x long: the measurements are taken with the
front as reference until a new measuring refer-
ence is set
2x long: the measurements are taken from the
unfolded end piece until a new measuring refer-
ence is set.
See drawing {F}.
Agatec AgaTape
Measuring

Single Distance Measurement

1x briefly: the laser is activated.
1x briefly: a distance measurement is taken.
The result is displayed immediately.

Continuous measurement

Distances can be measured with this function
1x long: a "beep" is sounded.A continuous
measurement is started.
1x briefly: the continuous measurement is
stopped.
The last measured value is displayed in the summary
line.
Minimum-/Maximum-Measuring
This function enables determining the minimum or
maximum distance from a specific measuring point,
e.g. the determination of room diagonals (maximum
value) or horizontal distance (minimum value).
Switching on continuous measurement (see above).
The corresponding maximum and minimum values are
displayed.
5
GB
GB
F
I
E
P
NL
DK
S
FI
RUS
PL
CZ
SK
SLO
H
Measuring