Switching On/Off; Setting The Instrument; Reference Setting - Agatec AgaTape Manual

abnormal use, and before, during and after important
GB
measurements.
GB
Make sure the Agatec AgaTape optic is kept clean and
that there is no mechanical damage to the bumpers.
F
CAUTION:
I
In using the instrument for distance measure-
ments or for positioning moving objects (e.g. cranes,
E
building equipment, platforms, etc.) unforeseen
events may cause erroneous measurements.
P
Precautions:
NL
Only use this product as a measuring sensor, not as
a control device. Your system must be configured and
DK
operated in such a way, that in case of an erroneous
S
measurement, malfunction of the device or power
failure due to installed safety measures (e.g. safety
FI
limit switch), it is assured that no damage will occur.
RUS

Switching on/off

PL
1x briefly: the instrument and the laser are
switched on.
CZ
The display shows the battery symbol
SK
the next button is pressed.
SLO
Pressing this button for longer switches the
H
instrument off.
The instrument switches off automatically after
three minutes of inactivity.
Operation

Setting the instrument

Press long until the desired unit is
displayed.
Possible units:
Distance
1. 0.000 m
1
2. 0'0'' /
16
1
3. 0 in /
16
4. 0.00 ft
CLEAR-Key
1x briefly: the last action is cancelled.
Illumination
The illumination switches on after pressing any
button. The illumination automatically switches off
20 seconds after the last button actuation.

Reference Setting

until
Default reference setting is from the rear of the
instrument.
The instrument can be set for the following measure-
ments:
• To measure from an edge (see drawing {D}), fold
out the stop bracket until it snaps in for the first
time. See drawing {E}.
4
Area Volume
0.000 m² 0.000 m³
0.00 ft² 0.0 ft³
0.00 ft² 0.0 ft³
0.00 ft² 0.0 ft³
Agatec AgaTape