Connecting A Macintosh Powerbook Computer - Sanyo PLC-XF10N MOD Owner's Manual

CONNECTING A MACINTOSH POWERBOOK COMPUTER

COMPUTER
ADB PORT ADB PORT
INPUT INPUT
MOUSE CABLE FOR
ADB PORT
(PROVIDED)
SERIAL PORT CABLE
(NOT PROVIDED)
AUDIO
INPUT
R
Amp.
Set the dip switches as shown in the table below depending on
the RESOLUTION MODE that you want to use before you turn
on the projector and computer.
RESOLUTION MODE
SW1
13" MODE (640 x 480)
ON
16" MODE (832 x 624)
OFF
19" MODE (1024 x 768)
OFF
21" MODE (1152 x 870)
ON
NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
NOTE: The Macintosh PowerBook requires the use of the PowerBook Video
Adapter shipped with the PowerBook.
VGA/MAC ADAPTER
(PROVIDED)
COMPUTER
OUTPUT
R
COMPUTER
AUDIO OUTPUT
L
AUDIO CABLE
(NOT PROVIDED)
COMPUTER
AUDIO INPUT 1
CONTROL PORT
OUTPUT 1
SERIAL
PORT
OUTPUT
AUDIO CABLE
(NOT PROVIDED)
SPEAKER
OUT
L
Speaker (L)
L
R
SW3 SW4
SW2 SW5
OFF
ON OFF OFF
ON OFF ON OFF
ON ON OFF OFF
ON ON
ON OFF
CONNECTING THE PROJECTOR
R L
USB 1 CONTROL PORT 1 AUDIO 1
R L
(MONO)
USB 2 CONTROL PORT 2 AUDIO 2
R
R L
(MONO)
AUDIO OUT
R/C JACK SERIAL PORT
R L
COMPUTER
AUDIO OUTPUT
Speaker (R)
SW1 ~ SW6
ON
SW6
OFF
OFF
OFF
OFF
OFF
VGA CABLE
(PROVIDED)
COMPUTER
INPUT 1
(ANALOG)
DIGITAL
ANALOG
G B H V
ANALOG RGB
VGA/MAC ADAPTER
ON
1 2 3 4 5 6
19