Sanyo PLC-XF10N MOD Owner's Manual page 15

CONNECTING AN IBM-COMPATIBLE DESKTOP COMPUTER
(DIGITAL INPUT CONNECTION)
NOTE: This connection need optionally sold Graphic Accelerator Board.
For this information, contact to your authorized dealer.
COMPUTER
SERIAL PORT PS/2 PORT
INPUT INPUT
MOUSE CABLE FOR
PS/2 PORT
(PROVIDED)
MOUSE CABLE FOR
SERIAL PORT
(PROVIDED)
SERIAL PORT CABLE
(NOT PROVIDED)
AUDIO
INPUT
L
Amp.
NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
Before using with digital connection, install (Plug in) Graphic Accelerator
Board into PCI bus slot of the computer and set up the computer
following instructions in the Graphic Accelerator Board package.
GRAPHIC
ACCELERATOR
BOARD
INSTALL (PLUG)
INTO PCI BUS SLOT
R
COMPUTER
AUDIO OUTPUT
L
COMPUTER
AUDIO INPUT 1
CONTROL PORT
OUTPUT 1
SERIAL
PORT
OUTPUT
AUDIO CABLE
(NOT PROVIDED)
SPEAKER
OUT
R
Speaker (L)
L
R
CONNECTING THE PROJECTOR
MONITOR CABLE
(NOT PROVIDED)
ANALOG
DIGITAL FLAT
OUTPUT
PANEL CABLE
(NOT PROVIDED)
DIGITAL
OUTPUT
AUDIO CABLE
(NOT PROVIDED)
COMPUTER
INPUT 1
(DIGITAL)
R L
USB 1 CONTROL PORT 1 AUDIO 1
ANALOG
R L (MONO)
USB 2 CONTROL PORT 2 AUDIO 2
R
R L
(MONO)
AUDIO OUT
R/C JACK SERIAL PORT
R L
COMPUTER
AUDIO OUTPUT
DIGITAL
G B H V
ANALOG RGB
Speaker (R)
15