Installation; Positioning The Projector; Adjustable Feet - Sanyo PLC-WXE45 Owner's Manual

Installation

Positionin� the Projector
For the projector positioning, see the figures below.
The projector should be set perpendicularly to the plane of the screen.
Note:
•This projector is not equipped with an optical zoom. To adjust the screen size, change the throw distance.
• The brightness in the room has a great influence on picture quality. It is recommended to limit the ambient
lighting in order to get the best image.
•All measurements are approximate and may vary from the actual sizes.

Adjustable Feet

Projection angle can be adjusted up to 10.0 degrees with
the adjustable feet.
Lift the front of the projector and pull the feet lock latches
1
on both sides of the projector upward.
Release the feet lock latches to lock the adjustable feet
2
and rotate the adjustable feet to adjust the position and
tilt.
To retract the adjustable feet, lift the front of the projector
3
and pull and undo the feet lock latches.
Keystone distortion of the projected image can be
corrected by remote control operation or menu operation
(pp.22, 41).
2.826' (86.1 cm)
1.726' (52.6 cm)
Screen Size 50"
(W x H) mm
16:10aspect ratio 1077 x 673
Throw distance 1.726' (52.6 cm) 2.826' (86.1 cm) 3.927'(119.7 cm)
A
0.623' (19.0 cm) 0.846' (25.8 cm) 1.069' (32.6 cm)
3.927' (119.7 cm)
80"
50"
80" 110"
1723 x 1077 2369 x 1481
Adjustable Feet
(Inch Diagonal)
110"
A
Feet Lock Latches
1