How To Use The Test Light - PetSpy p-collar 320 Manual

Step How to pair the Remote
Transmitter & Receiver Collar
If your Receiver Collar does not beep when the TONE
Button of the Remote Transmitter is pushed,or if you
feel the Receiver Collar is not responding to the Remote
Transmitter, follow these steps to pair:
Receiver Collar off. Restart, press and hold the On/Off
Button until the Green LED flashes every second on
within which pairing should be completed.
2. Press and hold the TONE , VIBRA or Shock Button
of the Remote Transmitter until the Green LED Light
on the Receiver Collar flashes rapidly for 5 times,
indicating pairing is completed.
Two Dog System
NOTE: If you wish to add another Receiver Collar to
the training system, extra Receiver Collars are available
where you bought your unit.
Remote Transmitter
1. Switch Dog1 to Dog2 by pressing and releasing the
Dog 1/2 Button.
2. Turn on the Receiver Collar for Dog 2, press any
Mode Buttons to verify function.
3. If Dog 2 Receiver Collar does not respond. Pairing
may be needed.Repeat steps in How to pair the Remote
Transmitter & Receiver Collar above.
1
Step

How to use the Test Light

1. Turn the Receiver Collar on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press the SHOC
4. The Test Light will flash.
Note: At higher Shock Levels, the Test Light will flash
brighter.
5. Turn the Receiver Collar off.
Save the Test Light for future testing.
Note: If the Test Light does not flash, recharge the
Receiver and re-test. If Test Light still does not flash,
contact us for Customer Service.
utton on the Remote Transmitter.
1