Connecting The Ac Power Cord - Sanyo PLC PLC-XP100BKL Owner's Manual

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–120 V or 200–
240 V AC and it automatically selects the correct input voltage. It
is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service station.
Connect the projector with all peripheral equipment before turning
on the projector.
CAUTION
For safety, unplug the AC power cord when the projector is not
in use. When the projector is connected to an outlet with AC
power cord, it is in stand-by mode and consumes a little electric
power.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.

For the U .S .A . and Canada
Ground
To the AC Outlet.
(10 V AC)
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and
must be easily accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(00–40 V AC)
For the U .K .
To the AC Outlet.
(00–40 V AC)