Replacing The Filter; Resetting The Filter Counter - Sanyo PDG-DWL2500 Owner's Manual

Sanyo projector user manual
Hide thumbs Also See for PDG-DWL2500:
Table of Contents

Advertisement

Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter become
clogged with dust particles, it will reduce cooling fans' effectiveness and may result in internal heat buildup
and adversely affect the life of the projector. If a "Filter warning" icon appears on the screen, replace the Filter
immediately. Replace the filter by following the steps below.
1
Turn off the projector, and unplug the AC power cord
from the AC outlet.
2
First, clean up the dust on the projector and around the
air vents.
3
Loosen the screw and open the lamp cover and lift the
filter out of the projector.

Put the new one back into the position, and close the
lamp cover and secure the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the filter counter.
CAUTION
- Do not operate the projector with the filter removed.
Dust may accumulate on the optical elements
degrading picture quality.
- Do not put anything into the air vents. Doing so may
result in malfunction of the projector.
- Do not wash the filter with water or any other liquid
matter. Otherwise the filter may be damaged.
RECOMMENDATION
We recommend avoiding dusty/smoky environments
when you operate the projector . Usage in these
environments may cause poor image quality .
When using the projector under dusty or smoky conditions,
dust may accumulate on a lens or optical elements inside
the projector degrading the quality of a projected image.
When the symptoms above are noticed, contact your
authorized dealer or service center for proper cleaning.

Resetting the Filter Counter

Be sure to reset the Filter counter after replacing the Filter .
1
Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
8
2
Use the Point
ed
buttons to select Filter counter
and then press the SELECT button. Use the Point
buttons to select Filter counter reset and then press
the SELECT button. Filter counter Reset? appears.
Select yes to continue.
3
Another confirmation dialog box appears, select yes to
reset the Filter counter.

Replacing the Filter

ed
buttons to select Setting and
or the
button.
SELECT
Maintenance and Cleaning
Filter
Filter counter
ed
Lamp Cover
Screw
Filter counter
Reset? appears.
Select yes, then
another confirmation
box appears.
Select yes again
to reset the Filter
counter.
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents