Table of Contents
Advertisement
Antenna Connections
CAUTION:
When installing an outdoor antenna, follow the installation
instructions in the attached "IMPORTANT SAFETY
INSTRUCTIONS".
FM outdoor antenna
(not supplied)
Ground
Antenna discharge unit (not supplied)
AM loop antenna
Plug
75-ohm coaxial cable
(not supplied)
FM antenna
The FM indoor antenna lead wire is sufficient to receive most
local FM broadcasts and should be connected to the rear FM
75Ω terminal. Extend the antenna lead wire as straight as possible
and, while listening to the sound from the system, secure it in a
position where the best FM reception is found.
In fringe areas, or where reception is distorted or noisy, an FM
outdoor antenna (not supplied) should be connected instead of
the FM indoor antenna lead wire. The terminals will accept 75-
ohm coaxial cable.
AM antenna
The AM loop antenna is sufficient to
receive most local AM broadcasts.
Assemble the loop antenna.
Unwind the antenna wires, then
connect the plug to the AM LOOP
terminal. If you have difficulty inserting
the plug, turn it over and reinsert it.
Place the loop antenna in a position
which yields the best AM reception, or
attach it to a wall or other surface as
shown.
Note:
To minimize noise...
•
Keep the speaker wires, power cord and all other system
connection cables away from the loop antenna.
•
Do not place the antenna close to a TV or speaker.
FM indoor antenna
lead wire
1
3
2
Screws (not supplied)
Additional Connection Examples
To enjoy your TV sounds
If your TV has the audio output jacks,
connect an audio cable (not supplied) from
the audio output jacks of the TV to the
VIDEO (AUDIO) IN 1 jacks.
nd
2
video equipment input jack (VIDEO (AUDIO) IN 2)
Connect an audio cable (not supplied) from the audio output
jacks of the video equipment to the VIDEO (AUDIO) IN 2 jacks.
Headphones jack (PHONES)
Connect a pair of stereo headphones with miniplug (8 ohms - 32
ohms, not available from SANYO) to the PHONES jack for
monitoring or for private listening. The speakers are automatically
disconnected when headphones are connected.
Power Supply
Connect the power cord to a 120VAC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting the
plug, turn it over and reinsert it. If the unit will not be used for a
long time, disconnect the AC plug from the AC outlet.
Notes:
•
Before plugging the power cord into an AC outlet, make sure
that all the connections have been made.
•
The unit is not disconnected from the AC power unless the
power cord is unplugged from the AC outlet.
2
1
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Section 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
-E11-
TV
L
AUDIO
OUTPUT
R
Audio cable
(not supplied)
PHONES
Need help? Call
1-800-813-3435
Advertisement
Table of Contents
