Janome Air Thread 2000D Professional Instruction Manual page 22

⁄ 1
⁄ 2
!6
⁄ 3
!7
!8
@ 1
⁄ 4
⁄ 5
o
!6
!9
@ 0
@ 2
⁄ 1 Raise the looper threader lever until it clicks into
place.
!6 Looper threader lever
⁄ 2 Lower the looper threader lever until it knocks into
place.
⁄ 3 Make sure that the thread comes out from the hole of
the lower looper tip.
!7 Thread end
!8 Hole of lower looper tip
* If the thread does not come out from the hole,
follow the procedure from step ⁄ 1 again.
* If the thread comes out behind the pipe, use the
tweezers to draw the thread toward you between
the lower looper and the pipe.
!9 Thread (behind the pipe)
@ 0 Pipe
@ 1 Lower looper
⁄ 4 Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
@ 2 Upper knife
⁄ 5 Return the lower threader switch lever to the "SEWING"
position.
o Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.
21