Advertisement
a.
To get cap started, press against the battery pack in order to overcome the Dual-Gasket seal compression. You will notice
slightly increased friction as you tighten the cap.
b.
NOTE: The Dual-Gasket design is necessary to create a gas-tight and waterproof seal, with the required reliability.
4.
Adjust head band to properly fit the individual user.
BATTERY LIFE:
STAGES OF BATTERY LIFE:
The FoxFury Performance Intrinsic Lights will transition through three (3) different stages of battery life as the batteries run down to their
end-of-life condition:
NORMAL
RESERVE
EMERGENCY
*The above chart indicates information tested with Alkaline Batteries.
When in the Emergency Stage, (while the batteries seem to be almost expended), the brightness can be temporarily increased:
Turn the Foxfury light "OFF" for 3-5 minutes.
When turned back "ON", the unit will come on at about twice the brightness for a short period of time (2 to 4 minutes), and then
return to the normal low level output for the remaining time or until cycled again.
Each successive time will require a longer wait of "OFF" time, resulting in a shorter Higher Brightness period.
Expected Hours of Use according to Stage
STAGE
NORMAL
RESERVE
EMERGENCY
FoxFury Lights are tested for battery-life using fresh Duracell alkaline batteries and continuous run-times. Battery life can be extended by
keeping them warm in cold weather or turning the unit off when it is not needed. Your own body heat can keep a spare set of batteries
ready for use, or slightly extend the life of an almost exhausted set when they are cold.
PRODUCT DURABILITY, ENVIRONMENTAL CONSTRAINTS & CERTIFICATIONS:
Meets NFPA 1971-2007 Fire Resistant Requirements: 500°F /260°C for 30 minutes
-
STRAPS:
Both Intrinsic Models include a Silicone Strap.
CABLE GUIDE:
A black cable guide with Velcro is included with your headlamp. It is best used when wrapped around both the strap and cable, which makes
the cable less likely to be caught or snagged on any surrounding objects.
CARE/CLEANING:
Your FoxFury is a professional tool, but regular maintenance and care of your headlamp will maximize its performance. As needed, wash
your FoxFury using a soft washcloth, clean water and a mild soap. Be sure that the battery pack is sealed before washing. When done, pat
dry with a damp cloth. Keep the dual gasket ring seal area lubricated with silicone based grease.
DUAL GASKET CARE
•
Use silicone based lubricant grease around the dual gasket seal on the battery pack, and the matching area of the cap's inside.
•
Every 3-5 battery changes, re-apply silicone grease to the gaskets and mating surface inside the battery case cap.
Fresh batteries provide 6 to 8 hours (constant ON) of Normal mode operation.
This stage begins when 50% or slightly less of the initial starting brightness is present. 22 to 24 LEDs will
remain "ON", at reduced brightness, for an additional 1 to 2 hours, when using a set of alkaline batteries.
This reduction in brightness is intended to alert you that it is time to change the batteries. A shorter Reserve
stage time is to be expected in Cold temperatures.
A few additional LEDs may dim or go out completely during this stage. Most LEDs will remain ON and
continue to output a useful light level for an additional 30 hours (or longer in warm temperatures). This
minimum level of lighting is enough to read a map, act as a beacon or marker, or walk at a moderate pace
(4 to 12 Foot-candles).
# of LEDs ON
# OF Hours of Use
24
22 - 24
20 - 24
30 - 45
EMC
-
IPX-7
STAGES OF BATTERY LIFE
Total Hrs
6 – 8
6 – 8
1 – 2
7 – 10
37 - 55
Foxfury_Performance_Intrinsic_Manual_11_17REV.Doc7
Page 2
Advertisement
