Foxfury Lighting Solutions Performance Series Instruction Manual

TURNING YOUR PERFORMANCE INTRINSIC LIGHT ON/OFF:
Tap Switch: Once batteries are installed and the battery cap is securely tightened, the tap switch will then control the ON-OFF function of the
headlamp. In case of suspected damage to the headlamp, turn unit off at both the tap switch and the battery pack cap.
The battery cap can also act as an ON-OFF switch:
•
To turn ON: rotate CLOCKWISE, ½ to ¾ of a turn past the ON point.
• To turn OFF: rotate COUNTER CLOCKWISE, ½ to ¾ of a turn past the initial OFF point to ensure the light remains OFF.
•
Light can be turned ON and OFF more conveniently via the Power Switch on top of the light bar (on left side).
NOTE: Make sure to turn light OFF when not in use.
ACCEPTABLE BATTERY TYPES:
The Performance Intrinsic Lights require four (4) AA batteries each. Alkaline or Lithium Iron are acceptable (1.2 to 1.6V each).
•
Alkaline battery types (actual run time will depend upon battery quality and charge):
Duracell Ultra (M3) Copper-Top Alkaline AA batteries, P/N MX1500 (best)
o
Duracell Copper-Top Alkaline AA, P/N MN1500 or PC1500 (good)
o
Eveready Alkaline AA batteries, P/N E91 (acceptable)
o
•
Approved Lithium Iron (1.5Vdc) battery: (ideal for cold weather operation)
Eveready Energizer L91 AA size, Lithium Iron, Li-Iron Disulfide (Li-FeS
o
Caution: 3Vdc, 3.3Vdc or 3.6Vdc Lithium batteries are not approved
o
BATTERY INFORMATION & WARNINGS:
•
The warmer the batteries remain while in use, the longer their life (room temperature to body temperature is ideal).
•
Depending on temperature and battery brand used, an average of eight (8) hours performance is expected with each set of fresh
batteries.
•
Do not mix different brands of batteries, or new batteries with used batteries.
• Do not mix battery types (lithium with alkaline).
• Respect the polarity of the batteries when installing them in the battery pack. Failing to do so may result in gaseous emissions, and/or
caustic chemicals from leaking batteries. With just one battery installed backwards, the unit will function for a much shorter time than
normal, the reversed battery may become hot and may emit a gas or leak caustic chemicals. If this occurs; using plastic gloves, remove
all batteries, and wash/clean the inside of the battery pack with mild soap and lots of water. Afterwards, dry the inside of the battery
pack well, first with a dry cloth or paper towel, and finally, a hair dryer placed on Low or Medium heat settings and held at least 6" away
– will help finish up with the removal of any remaining
BATTERY INSTALLATION/REPLACEMENT:
For both Performance Intrinsic models:
1. Unscrew the cap of the battery compartment.
2. Install Four (4) each 1.5V AA batteries.
a. Respect appropriate polarity when installing (the inside of the battery pack indicates proper battery placement; see diagram
at right).
3. Twist cap back on.
Performance Series Instruction Manual for
FoxFury Model 400-FF417-2 & 400-FF417-5 Intrinsic Safety Headlamp
Manufactured by FoxFury, LLC
UL Class 1, Div 1, Grps A, B, C, & D; T6
UL Class 1, Div 2, Grps A, B, C, & D; T6
417
G rp s A B C D T 6 ,
), 1.5Vdc
2
Foxfury_Performance_Intrinsic_Manual_11_17REV.Doc7
moisture.
Page 1