Goal Alignment - PROformance Hoops Pro Series Installation & Owner's Instructions

Internal jack adjustable height goal system
Table of Contents

Advertisement

P P O O L L E E A A S S S S E E M M B B L L Y Y
S S t t e e p p 1 1 : : Remove five plastic plugs
from threaded holes in ground
anchor. Also remove hinge bolt 3 3
and nut (these will be used in
Step 3.)
N N O O T T E E : : Use protective padding to
protect pole finish.
S S t t e e p p 2 2 : : Unpack pole and jack.
N N O O T T E E : On the all models, the jack
assembly is already installed in the
pole.
S S t t e e p p 3 3 : : Align pole hinge 1 1 with
anchor plate hinge 2 2 and insert
bolt 3 3 (#2 in parts list) and nut.
S S t t e e p p 4 4 : : Lift pole to approximately
30º and attach lock plate 4 4 to
ground anchor and pole.
2 2 0 0
5 5
w w w w w w . . p p r r o o f f o o r r m m a a n n c c e e h h o o o o p p s s . . c c o o m m
P P r r o o S S e e r r i i e e s s I I n n t t . . J J a a c c k k S S y y s s t t e e m m I I n n s s t t r r u u c c t t i i o o n n s s
I I M M P P O O R R T T A A N N T T : The 30º pole
installation angle MUST be
maintained until pole is raised in

Goal Alignment.

S S t t e e p p 5 5 : : Pull jack assembly 5 5 out
slightly, remove packing and
protective materials from end of
jack and reposition jack in pole.
S S t t e e p p 6 6 : : Insert crank handle
through access hole and slide onto
shaft.
N N O O T T E E : : If a permanent crank
handle installation is desired, refer
to Permanent Crank Handle
Attachment.
4 4
1 1
2 2
1 1 . . 8 8 8 8 8 8 . . 3 3 5 5 3 3 . . 4 4 6 6 6 6 7 7
3 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro 672Pro 560Pro 660Pro 554Pro 454Pro 448

Table of Contents