Assembly And Starting - EINHELL TH-AC 190 Kit Original Operating Instructions

inflammable gases in the room.
•
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with spray-
ed water.
•
Operate the equipment only on a firm, level
surface.
•
During operation place the compressor on the
rubber feet on the compressor rear wheel.
•
Important! When you switch off the com-
pressor, excess air will escape at the safety
valve. This is not a fault, but arises in connec-
tion with the equipment's construction.

6. Assembly and starting

Important!
You must fully assemble the appliance before
using it for the fi rst time.
6.1. Power supply
Before you use the machine, make sure that the
mains voltage complies with the specifi cations on
the rating plate. Long supply cables, extensions,
cable reels etc. cause a drop in voltage and can
impede motor start-up. At low temperatures below
+5°C, sluggishness may make starting diffi cult or
impossible.
6.2 On/Off switch (4)
To switch on the equipment set the On/Off switch
(4) to position 1.
Move the On/Off switch (4) to position 0 to switch
off the equipment.
6.3 Compressed air hose with quick-lock
coupling (3)
Connecting:
Insert the nipple of the air tool into the quick-lock
coupling, the sleeve will spring forward automa-
tically.
Disconnecting:
Pull back the sleeve and remove the tool. Impor-
tant! When releasing the quick-lock coupling,
be sure to hold the coupling piece to protect
yourself against injury from the rebounding
hose.
Anl_TH_AC_190_Kit_SPK1.indb 18 Anl_TH_AC_190_Kit_SPK1.indb 18
GB
6.4 Tire pressure gauge with adapters (Fig. 2/
Item 6)
Working pressure in bar: 0-8
Range of applications:
The tire pressure gauge allows you to infl ate tires
easily and exactly. Use the pressure gauge to
check the tire pressure. If the tire pressure is too
high, you can reduce the pressure with the integ-
rated relief valve (e).
After fi lling with air, please check the set tire
pressure with a calibrated gauge, for example at a
petrol station.
The tire pressure gauge comes with a valve ad-
apter for car tire valves. Other valve types can be
fi lled using the supplied adapters (a - c).
Using the equipment as a blow-out pistol
(Fig. 3)
To use the tire pressure gauge as a blow-out pis-
tol you must fi rst unscrew and remove the hose
with the valve adapter for care tires.
Now the blow-out adapter (d) can be screwed to
the tire pressure gauge.
Range of applications:
For cleaning and blowing out hollow spaces or
hard-to-reach areas, as well as for cleaning soiled
equipment. The infi nitely variable trigger lever al-
lows an exact dosing of compressed air.
- 18 -
02.10.13 14:32 02.10.13 14:32