Mounting The Dst110; All Hull Types Except Cored Fiberglass; Figure 2 - Mounting Locations - Maretron DST110 User Manual

8. Full Keel Sailboats – Locate amidships and away from the keel at the point of minimum
deadrise.
Caution: Do not mount the DST110 in an area of turbulence or bubbles: near water intake or
discharge openings; behind strakes, fittings, or hull irregularities.

2.7 Mounting the DST110

The Maretron DST110 is mounted through the hull. If the hull is a cored fiberglass hull, please
follow the instructions in Section 2.7.2. For other hull types, please follow the instructions in
Section 2.7.1.

2.7.1 All Hull Types Except Cored Fiberglass

2.7.1.1 Hole Drilling
Warning: Always wear safety goggles and a dust mask.
1. Drill a 3 mm or 1/8" pilot hole from inside the hull. If there is a rib, strut, or other hull
irregularity near the selected mounting location, drill from the outside.
Revision 1.3
Figure 2 – Mounting Locations
Page 5