Connecting The Dst110 - Maretron DST110 User Manual

and taped in place. Fill the gap between the cylinder and hull with casting epoxy. After
the epoxy has set, remove the cylinder.
5. Sand and clean the area around the hole, inside and outside, to ensure that the sealant
will adhere properly to the hull. If there is any petroleum residue inside the hull, remove
it with either mild household detergent or a weak solvent (alcohol) before sanding.
6. Proceed with "Bedding" and "Installing" (see Sections 2.7.1.2 and 2.7.1.3).

2.8 Connecting the DST110

The Maretron DST110 provides a connection to an NMEA 2000
male connector located on the end of the cable attached to the DST110 (see Figure 6). You
connect the DST110 to an NMEA 2000
receptacle of the NMEA 2000
female connector). Be sure the cable is connected securely and that the collar on the cable
connector is tightened firmly. The DST110 is designed such that you can plug or unplug it from
®
an NMEA 2000 network while the power to the network is connected or disconnected. Please
follow recommended practices for installing NMEA 2000
Revision 1.3
Figure 5 – Preparing a Cored Fiberglass Hull
®
network by plugging the male connector into a female
®
network (note the key on the male connector and keyway on the
®
interface through a five pin
®
network products.
Page 9