DST110 User's Manual
2 Installation
2.1 Unpacking the Box
When unpacking the box containing the Maretron DST110, you should find the following items.
1 – DST110 Insert (with attached cable)
1 – Plastic Housing
1 – Plastic Hull Nut
1 – Rubber Bushing
1 – Safety Wire
1 – Blanking Plug
1 – Tube of Silicone Lubricant
1 – Instructions and O-ring for Non-Valve Housings
1 – DST110 User's Manual
1 – Warranty Registration Card
If any of these items are missing or damaged, please contact Maretron.
2.2 Housing Material
The DST110 is supplied with a plastic housing that is suitable for most installations. As an option,
Maretron offers both a bronze housing material. Please follow these recommendations for
determining the right material for your particular installation.
Plastic housing recommended for fiberglass or metal hulls only. Never install a plastic
housing in a wood hull since swelling of the wood may overstress the plastic causing a
fracture.
Bronze housing recommended for fiberglass or wood hulls. Never mount a bronze
housing in an aluminum hull because electrolytic corrosion will occur.
Never install a metal housing in a vessel with a positive ground system.
2.3 Tools and Materials
Water-based antifouling paint (mandatory in salt water)
Safety goggles
Dust mask
Electric drill with 10 mm (3/8") or larger chuck capacity
Drill bit:
Hole saw:
Countersink tool (for installing a flush housing)
Sandpaper
Mild household detergent or weak solvent (such as alcohol)
File (for installation in a metal hull)
Marine sealant
Additional washer [for aluminum hull less than 6 mm (1/4") thick]
Slip-joint pliers (for installing a bronze housing)
Zip-ties
Page 2
3 mm or 1/8"
51 mm or 2" (plastic or bronze housing)
Revision 1.3