Table of Contents
Advertisement
Chapter 1
Overview and Installation
Before you install, operate, or service a server, review the
Note
Information for Cisco UCS C-Series Servers
Supported Cisco Connected Safety and Security Hardware
Configurations
•
Supported NIC (GigE) Ports (Cisco Video Surveillance)
The Cisco Connected Safety and Security UCS series servers support the following:
•
•
Note
•
•
Server and Accessories Part Numbers
The following servers and field replaceable units (FRUs) are supported by the Cisco Connected Safety
and Security UCS Platform Series servers. Refer to these PIDs when ordering new or replacement
components.
Table 1-2
Part Numbers for the Cisco Connected Safety and Security UCS Platform Series
Item
Server appliance
KIN-UCSM5-1RU-K9
KIN-UCSM5-2RU-K9
Supported NIC (GigE) Ports (Cisco Video Surveillance), page 1-5
One 1-Gb Ethernet dedicated management port
Two 10-Gb Base-T Ethernet ports for video data
The LAN Ethernet posts are referred to as "Eth 0" and "Eth1" in the Cisco Connected Safety and
Security applications, such as Cisco Video Surveillance.
The Cisco Connected Safety and Security UCS series servers do NOT support the NIC redundancy
modes. Only the None option is supported: the Ethernet ports operate independently and do not fail
over if there is a problem.
Cisco CSS UCS Platform Series User Guide, KIN-UCSM5-1RU-K9 / KIN-UCSM5-2RU-K9
Supported Cisco Connected Safety and Security Hardware Configurations
Regulatory Compliance and Safety
for important safety information.
Specification
Cisco Connected Safety and Security UCS C220 M5 1-RU chassis
with motherboard, one 2.2 GHz 4114 CPU, 16 GB DDR4 memory,
and one 770W power supply (no drives and no option cards)
Cisco Connected Safety and Security UCS C240 M5 2-RU chassis
with motherboard, dual 2.2 GHz 4114 CPUs, 64GB DDR4
memory, and dual 1050W power supplies (no drives and no option
cards)
1-5
Advertisement
Table of Contents
