Advertisement
4. Click on the "Program" button to send the program to the StealthSwitch3
5. Once you click "program" you will receive a message that reads, "Device successfully
programmed"
6. NOTE: If you receive a message that says "Failed to Program Device" follow these
instructions:
a. You can reboot your computer or unplug the StealthSwitch3, wait 15 seconds,
plug back in and then click "program" again. You will need to repeat this driver
install procedure if you plug your device into a different USB port.
Notes:
• After programming, the software is no longer required and all settings are stored in the
SS3 hardware. It can even be unplugged and moved to another computer and retain
the programming.
• Click on "Help" for more features and information.
StealthSwitch3 Software Installation- Mac
1. Visit www.stealthswitch3.com/support/downloads to download your software
2. Click on "Download StealthSwitch3 Software for Mac" to begin download.
3. Unzip your file (**NOTE** StealthSwitch II and StealthSwitch3 software is identical)
©H-Mod, Inc.
www.stealthswitch3.com
P a g e | 6
Advertisement
