CAUTION:
Safety glasses must be worn during these next steps.
NOTE:
Bearing (3C) is a matched set and must stay as a set.
1.
Place Planet Gear (3F) with part number up onto press table. Install Internal Retaining Ring
(3C) into the groove of Planet Gear (3F).
2.
Use tool T147846 and Install both the Bearing Cups (3C) with wide face outside into bore of
the Planet Gear (3F). Ensure that the Bearing Cups (3C) has seated fully against the
Retaining Ring (3C).
3.
Install Bearing Cone (3C) into Bearing Cup (3C) then install the cone spacer. Install the
second Bearing Cone in to the opposite of the Planet Gear (3F).
4.
Apply grease and install Thrust Washer (3B) into the counter-bore in Carrier (3A) planet gear
window.
5.
Slide Planet Gear (3F) assembly into planet window of Carrier (3A) with part number facing
up.
Continued on Next Page
Planetary Final Drive Service Manual
Input Carrier Subassembly 29 & 40 to 1
26