Using The Multimedia Remote Control - Sanyo DS31820 Owner's Manual

USING THE MULTIMEDIA REMOTE CONTROL

Operates your TV, VCR, DVD Player, Cable converter box, and Satellite Receiver. To
program the remote control, see pages 9 ~ 11.
INSTALL BATTERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix different types of bat-
teries together.
– Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed
of properly in compliance with all applicable laws. For detailed information,
contact your local County Solid Waste Authority.
REMOTE CONTROL KEYS
➀
Mode Keys—Use these keys to program the remote
control and to select the operating mode (VCR, TV,
CABLE, DVD, SAT, or AUX). To Operate Your...
VCR—Press the VCR key;
Television—Press the TV key; Cable Box—Press
the CABLE key; DVD Player—Press the DVD key;
and Satellite Receiver—Press the SAT key.
Note: Make sure you hold down the mode key
while entering a code number, see page 9.
➁
Input Key—In the TV and Satellite modes, this
key selects the program source to display on the
screen (TV signal or signal from equipment con-
nected to the AV jacks). In the VCR mode, this key
functions as a VCR's TV/VCR key.
➂
Number Keys—Two keys must be pressed to select
a channel. Example: Press 0 then 6 to select channel
6. For cable channels 100 through 125, press and
hold the 1 key until C1–– appears. Then press the
other two numbers.
➃
Caption Key—See page 13.
➀
VCR TV
DVD SAT
➁
POWER
INPUT
1 2
➂
4 5
7 8
➃
0
CAPTION
MENU
CH
VOL
CH
MUTE
(Continued on page 8.)
QuickTips
Be sure batteries are
■
installed correctly.
Point the remote
■
control toward the
equipment you want to
operate. Objects bet-
ween the remote
control and the equip-
ment may cause
misoperation of the
remote control
function.
If the remote control
■
does not work: Press
TV key (see item 1).
The remote control
■
must be programmed
before it will operate
your VCR, DVD
Player, Satellite
Receiver, or Cable
Box. See pages 9~11.
Note: Sanyo VCR
CABLE
and DVD codes are
preprogrammed.
AUX
Cannot select
■
RESET
channel with number
keys. Press "0"in
3
front of numbers 1~9.
6
Example: Channel 05.
Adjusting the volume
■
9
level: Flashing Right
SLEEP
arrow indicates
volume is increasing
RECALL
and flashing Left
arrow indicates
VOL
volume is decreasing.
Need help?
DISPLAY
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
7 7