Using The Audio/Video Input Jacks - Sanyo AVM-3259G Owner's Manual

QuickTips
Make sure all cable
connectors are fully
seated on jacks.
Always match cables
according to the
colors; for right
RED
audio, for left
WHITE
audio and for
YELLOW
video.
A/V1 and A/V2 jacks
have identical func-
tions. Any compatible
video equipment can
be connected to either
set of jacks.
A solid Blue screen
with the word Video1
or Video2 displayed
means that the Video
mode is selected, but
no signal is being
detected at the
Video jack. Check
connection, and
turn on external
equipment.
You may be able
to use the remote
control to operate
your VCR, DVD,
Cable Box, and TV.
(See pages 7~8.)
12
USING THE AUDIO/ VIDEO INPUT JACKS
CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables. (Cables are not supplied.)
1. Connect VCR, DVD, DSS, or other equipment's Audio Out (R/L) to the TV Audio
Input (R/L) .
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV Audio (L) Input.
2. Connect VCR, DVD, or other equipment's Video Out to the TV Video Input
Optional
Connect VCR, DVD, or other equipment's S-Video Out to the TV S-Video In-1
Jack .
Note: Using the S-Video In-1 jack overrides the Video 1 jack
3. Press POWER to turn on the TV. Turn on external equipment also.
4. Press the INPUT key
equipment you have connected to the A/V1 and A/V2 jacks.
Follow the same procedure to connect other compatible video equipment to the second set
of A/V jacks.
Back View of a VCR
A/V JACKS
IN
RF
R- AUDIO -L
CHANNEL
CH3 CH4
OUT
R- AUDIO -L
DVD Player
to select program source: TV signal or signal from the
VIDEO
TV A/V Input
VIDEO
Rear Jacks
UHF/VHF/CATV
75Ω
.
VCR TV AUX
POWER
INPUT RESET
Remote Control
S-VIDEO IN -1
AUDIO
AUDIO
OUTPUT
VIDEO
(MONO)
AUDIO L VIDEO
INPUT R
1
L
AUDIO
R
VIDEO
INPUT
AUDIO L VIDEO
R
2
(MONO)
.