Generally Basical Safety-Indications; Packing And The Transport - holthausen elektronik ESW-small-Compact User Manual

Electronic Vibration monitoring Unit
ESW ® -small-Compact

1. Generally basical safety-indications

Don't use this device as the only invigilator, if a malfunctioning of ESW
lead to damages on goods or Persons.
To obtain the desired result be sure, that the device with its technical data fits to the bulk of
the object you want to supervise.
The sensor is sensitive to shock. A downfall out lower height to a hard substratum can
destroy the sensor.
The assembling place and the execution of the assembling of the sensor determine
decisively the quality of the sensor signal. The assembling may only happen through
qualified and instructed persons.
The electrical hook up is to be done by instructed persons. A mistake by the connection can
entail to faulty functions, outfall or ruination of the sensor and electronics.
The ESW ® should not be used on machines with a very energetic high-frequency solid-borne.
Through resonance apparitions in the sensor, the device can indicate a much too great or too
small value.
Powerful noise sources for instance inverters, in direct closeness of the sensor, electronics
or cabling, can result in faulty behaving of the apparatus.
Potential differences and balance currents in the mass guidance can result in faulty behaving
too.
The connection cable is resistant against many but not every type of chemical and
mechanical stress. Through a damaged cable chemicals could get inside the unit and
destroy the electronic. Then the unit would loose their function.
Therefore the conditions from the mounting surrounding must be checked. Then the cover
material from the cable have to be proofed if it resists these requirements. You can get an
overview from the chemical resistance of the cover material from us.

2. Packing and the transport

Note:
 The sensor is sensitive to shock. A downfall out lower height to an hard
substratum can destroy the sensor.
 Avoid to kink or tie a knot in the cable.
 Keep the electronic in a dry place.
 In case of a downfall or heckling or squeezing, could the casing or the operation
elements or the board get defects.
With adequate warning-labels and through a qualified packaging and storage, you can
protect the sensor and electronics at carriage against influences from outside.
holthausen
elektronik GmbH
4
® -small-Compact could