Advertisement
Available languages
Available languages
User manual / Bedienungsanleitung
Azimuth adjustments are facilitated through the small (1.5 mm) hex wrench (red marked screw)
on the bottom side of the armwand where the headshell enters the arm tube. Once you loosen this
screw, you´ll be able to rotate the headshell a small amount in either direction. Be sure to tighten
the screw when done.
Pic. 7: Azimuth adjustment
Wind the counterweight on the tonearm tube. You can adjust the tracking force of your cartridge by
turning the counterweight (shown in the picture below)
(green arrow = more tracking force
Pic. 9: Tracking force adjustment
8
Pic. 8: Screw to adjust the headshell
/
red arrow = less tracking
© clearaudio electronic GmbH, 2018/10
force).
Advertisement
