Related Manuals for Cando Magneciser
Summary of Contents for Cando Magneciser
- Page 1 01-8025 SHOULDER EXERCISER bi-directional exerciser with magnetic resistance for smooth operation Fabrication Enterprises Inc. PO Box 1500 White Plains, NY 10602 (USA) tel: 914-345-9300 fax: 914-345-9800 www.Fab-Ent.com ver 10/11...
-
Page 2: Table Of Contents
SHOULDER EXERCISER TABLE OF CONTENTS Safety Precautions ................Assembly Parts & Hardware Pack ............Mounting and Assembly ................ Parts List ....................Assembly Diagram .................. Electronic Monitor .................. Operating Instructions ................ -
Page 3: Safety Precautions
SHOULDER EXERCISER SAFETY PRECAUTIONS Read this instruction guide before using your Shoulder Exerciser and follow all safety precautions. CAUTION ● Check unit before each use to make sure it is in working condition. Never operate this unit if it is not functioning properly. ●... - Page 4 SHOULDER EXERCISER ● Wear comfortable clothes that allow freedom of movement and are not tight or restricting. ● Wear comfortable shoes with good support and nonslip soles. ● Breathe naturally, and never hold your breath during an exercise. ● Perform exercises consistently with proper technique, and with a full range of motion.
-
Page 5: Assembly Parts & Hardware Pack
SHOULDER EXERCISER ASSEMBLY PARTS HARDWARE PACK... -
Page 6: Mounting And Assembly
SHOULDER EXERCISER MOUNTING and ASSEMBLY STEP 1. Attach the Main Unit to the Main Frame Mounting (#11). Then secure it with four M8X50L Socket screws (#13), four Flat washers (#14) and four M8 Nylon Nut (#15). - Page 7 SHOULDER EXERCISER STEP 2. Secure the Main Unit to a level wall, board with four Hex Head screw (#16), four Flat washers (#17) and four Wall mounts (#18). Attach the Hand Grip (#20) to the Handle bar (# 03) and tighten it.
-
Page 8: Parts List
SHOULDER EXERCISER PARTS LIST DESCRIPTIONS Main Unit................ Decoration Plate ............Handle Bar ..............Electronic Monitor ............Resistance Control Knob ..........Knob ................Pop Knob ..............Upright Tube ..............Square Plug ..............Main Frame Mounting ............ Shaft Clamp ..............Hand Grip............... -
Page 9: Assembly Diagram
SHOULDER EXERCISER ASSEMBLY DIAGRAM... -
Page 10: Electronic Monitor
SHOULDER EXERCISER ELECTRONIC MONITOR FUNCTION “MODE” BUTTON Use “MODE” button to select functions: time, revolutions per minute, and total revolutions. Hold the “MODE” button for 2 sec- onds to reset all values. FUNCTIONS SCAN Press “MODE” button to select “SCAN” mode with a “SCAN”... -
Page 11: Operating Instructions
SHOULDER EXERCISER OPERATION INSTRUCTIONS Hold the Hand Grip (#20 on page 9), then exercise clockwise or counter-clock- wise. Before using your Shoulder Exerciser, please adjust the height of the Main Unit to a proper height. 1. Main Unit Height Adjustment Loosen the Knob (#06) and Pop Knob (#07), then adjust the Main Unit up or down to your desire position, then fasten them. - Page 12 Fabrication Enterprises Inc. P.O. Box 1500 White Plains, NY 10602 (USA) tel: 1-914-345-9300 fax: 1-914-345-9800 www.Fab-Ent.com Authorized CE representative: RMS UK Ltd. 28 Trinity Road Nailsea, Somerset BS48 4NU (UK) Cando and are trademarks of Goldberg ™ ©2011 FEI, all rights reserved...
Need help?
Do you have a question about the Magneciser and is the answer not in the manual?
Questions and answers