Fig - Makita HR2230 Technical Information

W
iring diagram
Fig. D-2
Brush holder unit
Brush holder lead wires
(black and white) must be
tight in this portion.
Fix the Brush holder
lead wires (black and
white) with these lead
wire holders.
Noise suppressor
built in Switch
(Noise suppressor is not
used for some countries.)
Light circuit
(only for HR2470F and
HR2470FT)
Power supply cord
Switch
Put the slack of Brush holder lead wire (white)
in this position.
Wiring of Brush holder
lead wires
(black and white)
Route Brush holder lead wire (black)
between projections of Terminal M1
and M2, and connect it to Switch
terminal M2.
Route Brush holder lead wire (white)
between Switch and Grip,
and connect it to Switch terminal M1.
Terminal M1
Switch
Rib
Wiring under
Power supply cord
Put Lead wire of Light
circuit into the groove.
Light circuit
(only for HR2470F and
HR2470FT)
P 20 / 20
Terminal M2
Grip portion