Hilti CF-DS 1 Operating Instructions Manual page 9

CF-DS 1 / CF-DS L
It is essential that the operating instructions
are read before the tool is operated for the
first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions are with
the tool when it is given to other persons.
Operating controls and parts
Foam can
Solid valve
Nozzle
Adaptor
Trigger with safety clatch
Adjustment knob
Contents
1. Handling
2. Cleaning
3. Manufacturer's warranty – tools
Printed: 07.07.2013 | Doc-Nr: PUB / 5103013 / 000 / 00
1. Handling
1.1 Preparation
– The substrate must be free of dust, grease and oil.
– The substrate must be thoroughly premoistened.
– The can, dispenser, substrate and ambient tempera-
ture must be between +5°C and +30°C.
– Thoroughly shake the foam can.
1.2 Mounting the can
– Screw the foam can onto the dispenser adaptor.
1.3 Dispenser regulation
– Release the trigger safety catch (tool is unlocked).
1.4 Use
– Varying pressure on the trigger controls the foam yield
and dosing the foam. This can also be restricted by
the rotary adjustment knob.
Important: Initial use
If a dispenser is straight from the factory, fully depress
the trigger for about 3 seconds to completely flush
through the dispenser.
Important: Work break
After every work break, the dispenser with the can
must be thoroughly shaken again.
Changing a can
– (This is only necessary if a can is empty.)
– Close the trigger safety catch (tool is locked).
– Screw off the can and screw on a new one thorough-
ly shaken can within one minute. If this is done, the
dispenser need not be cleaned and is immediately rea-
dy for use.
Important:
– Never use force to remove the can from the adaptor.
If necessary, loosen the can by tapping the adaptor
lightly with a nylon hammer.
– A can should always be screwed on the dispenser.
1.5 Dispenser locking
– Close the trigger safety catch (tool is locked).
Page
3
4
4
en
3