What To Do Before Operation; Names And Functions Of The Operating Section (Refer To Fig. 1-1, 1-2, 2 On Page [1]) - Daikin FFA25RV1A Operation Manual

2. WHAT TO DO BEFORE
OPERATION
Refer to the operation manual attached to the
indoor unit.
3. NAMES AND FUNCTIONS OF
THE OPERATING SECTION
(Refer to Fig. 1-1, 1-2, 2 on page
[1])
DISPLAY " " (SIGNAL TRANSMISSION)
1
This blinks when a signal is being transmitted.
DISPLAY " " "
(OPERATION MODE)
2
This display shows the current OPERATION
MODE. Operation modes supported depend on
the model that is connected.
DISPLAY "NOT AVAILABLE" (displayed
when operation is not supported)
3
When a button for a function that is not
supported on the connected model is pressed,
this displays for 2 seconds.
DISPLAY "
4
This display shows the set temperature.
DISPLAY "
5
This display shows PROGRAMMED TIME of
the air conditioner start or stop.
DISPLAY " " (AIRFLOW BLADE)
6
Refer to page 8, 9.
DISPLAY " " (FAN SPEED)
7
The display shows the set fan speed.
" (INSPECTION)
DISPLAY "
When the INSPECTION BUTTON is pressed,
8
the display shows the system mode is in.
Do not operate this button during normal use.
ON/OFF BUTTON
Press the button and the air conditioner
9
will start. Press the button again and the air
conditioner will stop.
FAN SPEED CONTROL BUTTON
10
Press this button to select the fan speed.
TEMPERATURE SETTING BUTTON
11
Use this button for SETTING TEMPERATURE.
BACKLIGHT BUTTON
12
Press this button to turn the backlight on or off.
SIGNAL TRANSMITTER
13
This sends the signals to the indoor unit.
3
" " " " " " "
" (SET TEMPERATURE)
" (PROGRAMMED TIME)
PROGRAMMING TIMER BUTTON
14
Use this button for programming "START and/
or STOP" time.
TIMER MODE ON/OFF BUTTON
15
Refer to page 9.
TIMER RESERVE/CANCEL BUTTON
16
Refer to page 9.
AIRFLOW DIRECTION ADJUST BUTTON
17
Refer to page 8.
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
" " (COOLING), "
18
" " (AUTOMATIC), "
" " (PROGRAMME DRY).
FILTER SIGN RESET BUTTON
19
Refer to the section of MAINTENANCE in the
operation manual attached to the indoor unit.
INSPECTION BUTTON
This button is used only by qualified service
20
persons for maintenance purposes.
Do not operate this button during normal use.
EMERGENCY OPERATION SWITCH
21
This switch is readily used if the remote
controller does not work.
RECEIVER
22
This receives the signals from the remote
controller.
OPERATING INDICATOR LAMP (Red)
23
This lamp stays lit while the air conditioner runs.
It flashes when the air conditioner is in trouble.
TIMER INDICATOR LAMP (Green)
24
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME INDICATOR
LAMP (Red)
25
Lights up when it is time to clean the air filter.
DEFROST OPERATION LAMP (Orange)
26
Lights up when the defrosting operation has
started.
" (HEATING),
" (FAN),
English