Daikin FFQ25B7V1B Operation Manual
Daikin FFQ25B7V1B Operation Manual

Daikin FFQ25B7V1B Operation Manual

Split system air conditioners
Hide thumbs Also See for FFQ25B7V1B:

Advertisement

OPERATION MANUAL

Split system air conditioners
FFQ25B7V1B
FFQ35B7V1B
FFQ50B7V1B
FFQ60B7V1B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FFQ25B7V1B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Daikin FFQ25B7V1B

  • Page 1: Operation Manual

    OPERATION MANUAL Split system air conditioners FFQ25B7V1B FFQ35B7V1B FFQ50B7V1B FFQ60B7V1B...
  • Page 3: Operation Range

    The setting temperature range of the remote controller is 16°C~32°C. Refer to the manual of the remote controller for more information. ° C ° C If your installation has a customized control system, ask your Daikin dealer for the operation that corresponds to your system. RS50-60 °C DB 21~32 ≤...
  • Page 4 The unit is individually operated. NOTE Contact your Daikin dealer in case of changing the combination or setting of group control and two remote controller control systems. Information specifically for the Australian model can be found in "ANNEX II"...
  • Page 5 If the inside of an indoor unit is extremely contaminated, the temperature distribution inside a room becomes uneven. It is necessary to clean the inside of the indoor unit. Ask your Daikin dealer for details on cleaning the unit. This operation requires a qualified service person.
  • Page 6: Troubleshooting

    OPERATION lamp flashes and the "MALFUNCTION CODE" BURN-OUT OF THESE COMPONENTS. appears. figure 2 Measure: Notify your Daikin dealer and inform him/her of the display. Indoor unit If the system does not operate properly, except for the above Discharged air...
  • Page 7 How to clean the air outlet and outside panels Disposal requirements Clean with a soft cloth. Dismantling of the unit, treatment of the refrigerant, oil and eventual other parts, should be done in accordance with the relevant local and When it is difficult to remove stains, use water or neutral national regulations.
  • Page 8 ANNEX I ONLY FOR AUSTRALIAN MODELS AME AND FUNCTION OF EACH SWITCH AND 11 DISPLAY " " (TIME TO CLEAN AIR FILTER) DISPLAY ON THE REMOTE CONTROLLER Refer to "How to clean the air filter" on page 12 DISPLAY " "...
  • Page 9 ANNEX II ONLY FOR AUSTRALIAN MODELS Cooling, heating, automatic, fan, and program dry operation Adjustment Operate in the following order. For programming TEMPERATURE, FAN SPEED and AIR FLOW DIRECTION, follow the procedure shown below. Operation mode selector Temperature setting Press OPERATION MODE SELECTOR button several times and select the OPERATION MODE of your choice as follows.
  • Page 10 OTES Program timer operation Operate in the following order. The timer is operated in the following two ways. Programming the stop time ( ..The system stops operating after the set time has elapsed. Programming the start time ( ..The system starts operating after the set time has elapsed. The timer can be programmed a maximum of 72 hours.
  • Page 11 NOTES NOTES...
  • Page 12 Zandvoordestraat 300, B-8400 Oostende, Belgium 4PWEN18600-1...

This manual is also suitable for:

Ffq35b7v1bFfq60b7v1bFfq50b7v1b

Table of Contents