Advertisement
Items Needed:
Back Rail
M6x12 Screw (Qty: 8)
IMPORTANT: Before attaching Back Rail, adjust height of
Leg Panels to the planned Workbench location. See
Workbench Height Adjustment section on next page.
Attach Back Rail (E) to back of Left and Right Leg Panels:
• Align Back Rail end holes with holes in back of Left and
Right Legs.
• Tighten (4) M6x12 screws through Back Rail end holes
into Leg holes as shown in figure below.
Note: The Back Rail end flanges must be attached so that
they are on the outside of the Leg Panels.
• Once the Back Rail is attached, go back and fully tighten
all screws that were partially tightened up to this point in
the assembly process.
E
Items Needed:
Power Strip
Power Strip Cover
M6x12 Screw (Qty: 6)
• Insert the Power Strip (F) into the Power Strip Cover (G).
• Align the Power Strip Cover holes with the perimeter
holes of the opening for the Power Strip on the inside
of the Right Leg Panel.
• Tighten (6) M6x12 screws through Power Strip Cover
holes into Leg Panel holes as shown in the figure below.
Note:
• The power strip has receptacle holes for four 3-pronged
plugs. It also has two USB ports for charging electronic
devices.
• Once power strip is plugged in, push toggle switch to
RESET position for power strip operation.
E
F
G
Items Needed:
6
Cord Holder
M6x12 Screw (Qty: 2)
• With the aid of an assistant, set the the workbench in
upright position.
• Align the holes in Cord Holder with Cord Holder
attachment holes on outside of Right Leg Panel.
• Tighten (2) M6x12 screws through Cord Holder holes
into Right Leg Panel holes as shown in figure below.
Items Needed:
7
Bottle Opener (Qty:1)
M4x12 Screw (Qty: 2)
• Align the holes in Bottle Opener with Bottle Opener
attachment holes on left side of Crossbar.
• Tighten (2) M6x12 screws through Bottle Opener holes
into Crossbar holes as shown in figure below.
I
Note: The Left Leg Panel has pegboard holes through
which hooks can be attached for hanging hand tools, work
lights and similar items.
4
H
Advertisement
