GE Lumination RC Series Installation Manual page 7

Led luminaire, new construction frame

page of 7

/ 7
Bookmarks

Connect plugs:

3 pole to 3 pole

2 pole to 2 pole

Connect the two quick connectors and

reassemble the connector box.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-005 (A) / NMB-005 (A).

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

All trademarks are the property of their respective owners. Information provided is subject to

change without notice. All values are design or typical values when measured under laboratory

conditions. Current, powered by GE is a business of the General Electric Company.

www.currentbyge.com

Reassemble

connector box

IND259 (Rev 08/15/18)

Load springs into upright position by twisting the

springs upward and carefully insert the fixture to

the hole of the frame. Verify reflector trim is flush

with ceiling.