GE Lumination RC Series Installation Manual page 4

Wing nut
8
Place PSU box onto frame next to unused junction
box and secure with U-bracket by tightening wing nut.
Safety
tether
Feed button stop
and toggle through
hole in bracket
Toggle
Button stop
10
Attach the other end of the safety tether to the
fixture using one of the three holes located on the
fixture brackets. Feed the button stop and toggle
through the hole and slide into the hole in the
bracket. Allow the fixture to hang freely .
12
Cut cable tie on light fixture.
U-bracket
9
Take the provided safety tether and loop one end
of the tether around the L-bracket.
Connect two
quick connects
11
Plug together the light fixture to the driver enclosure
with the supplied quick connects and assemble the
connector housing when finished.
Position fixture so
L-bracket does not
interfere with springs
13 Align the fixture so that two of the three springs are
on each side of the L-bracket. This is necessary in
order to make sure that when the springs release,
the L-bracket does not interfere and prevent the
springs from making contact with the top of the
ceiling for proper support.
4
Loop around
L-bracket
Assembled connector
housing