QuickCable iSTART Li-Ion Power Pack Operator's Manual

The iSTART Li-Ion Power Pack is a compact, hand-held, power
source for charging or supplying power to most 12V or 19V
electronic devices. It's also powerful enough to jump start a
Operators Guide
12 volt gasoline engine on a car, truck, motorcycle, ATV or
watercraft.
8. 14.
10.
WARNING – Risk of Explosion or Fire
1. Failure to follow these instructions may result in personal injury,
9.
destruction of the power pack, or damage to your vehicle.
2. Read owner's manual before use.
3. Wear safety goggles whenever working around vehicle batteries.
4. Wear gloves and protective clothing.
13. Prior to use, test the iSTART Li-Ion Power Pack's battery level
by depressing the power button and refering to chart below.
12.
Recharge every 30 days or when the capacity indicator lights
indicate low charge. Fluctuations in temperature can
accelerate battery discharge. Check your unit often.
11.
Charging the iSTART Li-Ion Power Pack
NEVER USE ANY CHARGING DEVICES OTHER THAN THE
AC AND DC CHARGING DEVICES INCLUDED WITHIN, OR
7.
DAMAGE MAY RESULT!
6.
1.
5.
2. The iSTART Li-Ion Power Pack can be charged either with the
4.
3.
AC wall socket charger or the 12 volt DC power plug adapter
included.
1. Hi Power LED Flashlight
2. Jump Start Port 9. Wall Charger (AC)
Throughout the charge cycle, the capacity indicator lights will
19V Laptop Output Port
3. 10. 12V Power Plug Charger (DC)
flash one by one. During charging, each light will glow solid as
Capacity Indicators Laptop Cable Tips
4. 11.
the unit charges. Once all lights are glowing solid, the unit is
5. 5V USB Ouput Port Adapter Cord (black)
12.
then fully charged.
6. 12V Output Port 13. USB Cable & Cell Phone Tips
7. Input Charge Port 14. Carrying Case
8. Jumper Clamps
To charge mobile phones or other USB devices:
Risk of Battery Explosion, Fire or Failure
IMPORTANT: Verify that your mobile phone or device
• Failure to keep internal battery charged will lead to permanent
battery damage.
will accept a 5 volt charge rating.
• Connecting a discharged battery to charged system could cause
1) Insert your mobile phone or other device's USB cable to the
overheating or explosion.
5 volt USB output port (#5) of the iSTART Li-Ion and continue
To jump start a 12 volt gasoline engine vehicle:
to step 4.
IMPORTANT: Make sure the iSTART Li-Ion Power
2) If a charge cord is unavailable, select the USB cord (white
Pack is fully charged or has no less than 4 capacity
#13) and insert it into the 5 volt USB output port (#5) of the
indicators illuminated. DO NOT connect (#8)
iSTART Li-Ion.
jumper clamps to the unit until they are
3) Select the correct connector tip (white #13) for your mobile
first connected to the battery.
phone or other device and connect it to your device.
4) Depress the power button on the iSTART Li-Ion to begin Connect the red (positive +) jumper clamp to the positive
1.
charging or supplying power. terminal of the battery and connect the black (negative –)
jumper clamp to the negative terminal of the battery and
make sure there is a good connection.
To charge laptops or notebooks:
Insert the blue connector plug of the jumper clamps into
2.
IMPORTANT: Verify that your laptop or notebook
the iSTART Li-Ion Power Pack and fully insert it until the
will accept a 19V charge rating.
shoulder of the plug rests on the case.
1) Insert the adapter cord (black #12) into the 19 volt output
Start the vehicle and leave it running.
3.
port (#3) of the iSTART Li-Ion Power Pack.
Disconnect the blue connector plug from the iSTART Li-Ion
4.
2) Select the correct laptop cable tip (black #11) for your
Power Pack IMMEDIATELY.
laptop or notebook, attach it to the adapter cord (#12), and
WARNING – Damage may occur if the iSTART is attached
connect to your device.
to a running vehicle for more than 30 seconds after the
3) Depress the power button on the iSTART Li-Ion to begin
engine starts.
charging or supplying power.
5. Remove jumper cables from battery and return unit to case
for storage.
NOTICE: While in use, this unit can generate heat and
it is recommended to use in a well-ventilated area.
If the unit becomes HOT to the touch, disconnect
1. 2. 3.
and allow it to cool.
To use the 12 volt output port
• Always use care when using this product.
The 12 volt output port can be used for portable DVD, cameras,
• Do not use the power pack if any cable clamp or cord is
gaming devices, or other 12 volt electronics that require up to a
damaged.
10A power source.
• Do not short circuit the unit. Don't touch the clamps together
Insert the adapter cord (black #12) into the 12 volt output
1.
or to any conductive material.
port (#6) of the iSTART Li-Ion Power Pack.
• Disconnect the blue connector plug from the iStart Li-Ion
2. Connect the other end to your device.
Power Pack IMMEDIATELY. Damage may occur if the iStart is
Depress the power button on the iSTART Li-Ion Power
3.
attached to a running vehicle for more than 30 seconds after
Pack to begin charging or supplying power.
the engine starts.
To use the LED Flashlight
• If your iStart Li-Ion power pack requires service, follow the
The LED flashlight has multiple modes that allow it to be used directions in the warranty section. Do not attempt to open or
as a flashlight, a strobe light or an S.O.S. distress light. repair the unit. Unauthorized repairs will void your warranty.
• Check vehicle battery terminals before using the power pack;
Depress the power button on the iSTART Li-Ion Power Pack
1.
clean them if necessary.
and hold for 3 seconds to illuminate the flashlight mode.
• Only jump start when 4 to 5 indicator lights are illuminated.
2. Depressing the button a second time will initiate the strobe
• After approximately 10 seconds of continuous cranking, if the
mode.
disabled vehicle fails to start, stop and wait for 2 minutes.
3. Depressing the button a third time will initiate the S.O.S.
distress mode. This prevents damage to your power pack and to your
Depressing the button again will turn the light off. vehicle's system.
4.
• This appliance is not intended for use by young or infirm
Technical Specifications
persons without supervision.
Size: 160*75*28mm
• Do not use as a toy.
Weight: 414g / 14.5 oz.
• Do not allow the appliance to become wet.
Output: 2A @5V DC / 10A @ 12V DC / 3.5A @ 19V DC
• Do not submerse the appliance in water.
Input: 1A @ 14V DC
• Do not operate the appliance in explosive atmospheres, such as
Charge Time: Approx. 3 to 4 hours – empty to full
in the presence of flammable liquids, gases, or dust.
Starting Current: 225A
• Do not expose the appliance to heat.
Peak Current: 425A
• Do not store in locations where temperatures may exceed 70°C.
Operating Temperature: -20°C to 60°C
• Charge only at ambient temperatures between 0°C and 60°C.
Storage Temperature: Store unit at or above 0°C (32°F) as batteries
• Charge only using the charger provided.
4. 5.
will discharge faster at colder temperatures.
Limited warranty
Use your iStart safely
The Manufacturer warrants this product against defects in material and workmanship for one (1)
year from the date of original retail purchase. Quick Cable will, at its option, repair or replace
defective units.
Quick Cable encourages you to register your product at www.quickcable.com/register and to retain
your original sales receipt with this manual for warranty purposes.
Damage caused by misuse or improper connections, failure to follow prescribed operating
instructions, impact damage, or negligence is not covered by this warranty. The manufacturer
reserves the right to inspect units for improper use in determining warranty coverage.
EXCEPT FOR THIS LIMITED WARRANTY, THE MANUFACTURER HAS NOT MADE AND
SPECIFICALLY DISCLAIMS ANY WARRANTY OR REPRESENTATION OF ANY KIND, EXPRESS OR
IMPLIED, DIRECT OR INDIRECT, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY, AND ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.
THIS LIMITED, CONDITIONAL WARRANTY PROVIDES THE EXCLUSIVE REMEDY FOR ANY CLAIM
OR DAMAGE EXCEPT AS OTHERWISE REQUIRED BY LAW.
This warranty excludes and does not cover defects or failures of your POWER PACK due to any
cause other than defects in material or workmanship, including without limitation any malfunctions
or failures caused by repairs made by an unauthorized person, mishandling, modifications, normal
wear, improper storage and unreasonable use or damage.
IN NO EVENT SHALL THE MANUFACTURER BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL
DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential
damages so the above limitations or exclusions may not apply to you. This warranty gives you
specific legal rights and you may also have other rights which vary from state to state.
Any claim relating to the Portable Power Pack must be submitted within one (1) year of purchase
and must be sent to Quick Cable in the U.S.A or Canada.
If any portion of this warranty or limitation of rights and remedies is found to be unenforceable,
then the remainder of this document shall remain in full force and effect.
To obtain service under this warranty:
1. Call Technical Service toll free in U.S.A. 1 (800) 558-8667 or in Canada 1 (800) 728-1742. Have
your power pack near the phone and a technician will help you diagnose the problem.
2. Be prepared to establish proof and date of purchase.
3. Any misuse of this unit will void this warranty.