Fitting The Battery - McGREGOR MCR2433 Original Instruction Manual

Prepare
Battery Charging (continued)
The indicator lights on the charger show the charger status:
Symbol
The intelligent charger measures the charge level of the battery and charges the battery
accordingly with the required current and voltage, based on battery temperature and
voltage. This ensure maximum battery life, charge the battery fully before storage.
A flashing red LED light on the charger indicates that the battery temperature is not within
the charging temperature range of -5°C– 50°C or the charging current is too high. As soon
as the permitted temperature and the charging current ranges are reached, the battery
charger will automatically switch to charging.
After continuous or repeated charging cycles without interruption, the charger may warm
up. This is normal and does not indicate a technical defect of the battery charger.
Rapidly flashing green LED's indicates that the battery voltage is low, the battery will
receive an extended charge cycle approximately 30minutes longer. This does not indicate
a defect with the battery.

Fitting the Battery

• To remove the battery, stop the lawnmower, lift the battery cover and remove the isolator
key. Active the release latch on the battery and slide the battery out from the chamber.
• Lift the battery cover on the lawnmower deck, slide the battery along the guide rails
ensuring that it locks into position.
Indicator lights
red, flashing
red,
continuous
green,
flashing
green,
continuous
Customer Helpline 0345 605 2063
Status
charging paused, see
instructions below.
connected to power supply
charging
fully charged
23