Safety Devices; Lid's Magnetic Sensor; Extraction Door's Grill - Telme GEL 20 Operating Instruction

English
Operating instructions
• The beater and the cylinder are have been assembled with precision: therefore they are sensitive to changes of
temperature, which could cause breakdowns or damages to the machine's mechanical parts due to thermal dilatation.
NEVER expose to abrupt temperature changes the parts subject to refrigeration: DO NOT pour water in the cylinder
immediately after ice-cream has been produced.
• For the above reason, in the event that you have turned on the refrigerator without inserting the beater in the cylinder
first, wait for the cylinder to reach room temperature, then proceed to install the beater.
»–› In the event of the use of the machine being no longer required, deactivate the machine by severing the electric cable
(after unplugging it from wall socket). In addition, follow these recommendations:
- avoid dispersing the freezing gas and the oil contained in the machine;
- carry out the draining and/or recycling according to the local provisions of the law currently in force on this matter.
2 S
AFETY DEVICES
D
O NOT ALTER THE SAFETY DEVICES AND DO NOT UTILIZE THE MACHINE IF THE SAFETY
DEVICES ARE DAMAGED OR MALFUNCTIONING
T
HE MANUFACTURER IS NOT RESPONSIBLE FOR POSSIBLE DAMAGES CAUSED TO PEOPLE
OR OBJECTS BY THE ALTERING OR BYPASSING SUCH DEVICES OR RELATIVE CIRCUITS
2.1

Lid's magnetic sensor

The magnet [1] and the magnetic contact [2] must be assembled as follows: the grooves [3] and the stencilled semicircle [5]
on the bottom of the magnet [1] must coincide with the grooves [4] (marked by a white line down the side) and the stencilled
semicircle [6] on top of the magnetic contact [2]. The device will not work unless all parts have been correctly
assembled in accordance with these instructions.
2.2

Extraction door's grill

This safety device, featuring an approved type magnet [1] and a magnetic contact [2]
avoids accidents caused by the accidental starting of the beater when the lid is open.
In consequence the device can't operate when the lid is open, and if it is opened
during its functioning the beater immediately stops.
In any case the lid's magnetic sensor MUST NOT be considered a control to be used
for the normal stop of the device.
DURING THE NORMAL USE, THE DEVICE MUST BE STOPPED ONLY
BY USING THE BUTTONS ON THE CONTROL KEYPAD, AND NOT BY
OPENING THE LID.
In large-sized models, supplied with extraction door, a fixed protection grill [3] prevents,
as far as possible, fingers or objects from being ACCIDENTALLY inserted in the chute.
In order to insure normal operation it is not possible to adjust the fixed grill as to prevent
fingers and objects from being VOLUNTARILY inserted through the extraction chute
(according to Machines Directive 89/392/CEE and ensuing modifications, Appendix
I, Art. 1.1.2.b, 3 paragraph).
rd
RESIDUAL HAZARD: D
FINGERS OR OBJECTS THROUGH THE GRILL OF THE
EXTRACTION DOOR WHEN THE MACHINE IS IN FUNCTION
The user is warned of the above RESIDUAL HAZARD (89/392/CEE and ensuing
modifications, Appendix. 1, Art. 1.1.2.b, 3
affixed next to the extraction chute.
D
O NOT HANDLE OR REMOVE THE GRILL
TING IN THE EXTRACTION DOOR
.
O NOT FOR ANY REASON INSERT
paragraph and 1.7.2) by a plate [30]
rd
!
5
.
.
[3] -
FROM ITS SET