Initial Functional Test - Telme GEL 20 Operating Instruction

10
5.4

Initial functional test

At the end of the installation, and before utilising the machine, it is indispensable to let a qualified
technician check the correct connection, by performing the following procedure.
- Before starting, check that the socket's Main Switch is in the position "0";
- check that Beater's Switch [24] on the machine is in the STOP position
applicable) is on OFF position;
- plug in and turn socket's Main Switch to position "1";
- turn Principal Switch
Remove the beater from the cylinder before carrying on the check, to avoid letting it function
dry. ATTENTION: Follow the directions reported on Par. 7.2 - Disassembly of parts.
ALWAYS
YOUR HANDS OR ANY OBJECT INSIDE THE REFRIGERATING CYLINDER
- Open the lid, unscrew the fixing knob [7], pull out the beater [6] from the cylinder, then close the lid.
Note: large-sized models do not operate when tie lid is open.
- turn Beater's Switch [24] to BEATING
CLOCKWISE the machine is correctly connected and ready to be used;
Note: do not unnecessarily start the refrigerator.
- TRIPHASIC INPUT MODELS ONLY: If the rotation is COUNTERCLOCKWISE, the connection to the triphase
power supply is wrong, and must be changed proceeding as follows:
[23] (if applicable) to ON position: its indicator lamp should light up;
STOP THE MACHINE BY TURNING THE
position and check beater's shaft by looking through the lid. If it turns
- stop machine by turning Beater's Switch [24] to STOP position
turn Principal Switch
- Open the plug's shell and invert TWO of the THREE conductors connected at the
phases (R-S, R-T or S-T);
- Close the plug's shell, plug in the machine and repeat the test.
(centre) and that Principal Switch
B
EATER
[23] to OFF;
T '
URN THE SOCKET S BREAKER TO THE
;
UNPLUG MACHINE
' S [24]
S WITCH BEFORE INTRODUCING
.
"0"
POSITION
English
Ice cream freezer
[23] (if
(centre) and
,
THEN