Advertisement
PREPARATION
• Cable outlet 599 mm alternative 680 mm from the the lower edge, with the
bottom lid mounted
• Recommended height: about 120 mm from the floor.
• Cable: H05V-U (EK)
H05V-K (RK) is okay to use wire end ferrules
Minimum cross section area according to cable standard
HD21 is 0.5 mm2 for EK and RK
• When mounted outdoors: Drill a drain hole in marked depression in the bottom lid.
MOUNTING AND INSTALLATION
• Remove the top lid
next page, and pull out the push front
• Set the dip-switches as desired, as described on the last page
• Adjust the length of the wire from the wall box to the connection terminal
with a good margin.
• Thread the cabling through the cable outlet
• Install the cabling according to diagram
• Slide the push front
• Mount outer profile
• Mount the top lid
• Turn on, wait a few seconds until the unit starts.
TECHNICAL SPECS
Dimensions
Power supply
Connection cable
Power consumption
Relay, max rated current
Material Outer profile and Push front
Material Lids
and bottom lid
A
down the outer profile
F
with screws at screw holes
E
and bottom lid
A
799 x 95 x 25 mm
18-30 VDC
2 wires for power supply
2 wires for signaling door auto-
matics
Standby ≈ 30mA
Activated ≈ Max 47mA
Maximum per pole 2A
Aluminum
Polyamide
in accordance with image on the
I
from the outer profile
F
on the outer profile
C
J
so they are edge to edge
E
and
B
so it "clicks"
I
E
E
I
Advertisement
