Advertisement
Quick Links
Advertisement
Related Manuals for Prismatibro Prisma Button 800
Summary of Contents for Prismatibro Prisma Button 800
- Page 1 MANUAL INSTALLATION ELBOW SWITCH ACTIVATION PANEL...
-
Page 2: Mounting And Installation
PREPARATION • Cable outlet 599 mm alternative 680 mm from the the lower edge, with the bottom lid mounted • Recommended height: about 120 mm from the floor. • Cable: H05V-U (EK) H05V-K (RK) is okay to use wire end ferrules Minimum cross section area according to cable standard HD21 is 0.5 mm2 for EK and RK •... - Page 3 Dismantling top and bottom lid Top lid Screw hole Cable outlet Circuit board Outer profile Push front (front) Push front (back with electronics) Screw holes Bottom lid Connection diagram 24 V Relay 2 Pole 2 Relay 1 Relay 2 Pole 1...
- Page 6 DIP-SWITCH • There are 8 dip-switches on the circuit board. • When delievered - All dip switches are set in OFF mode. • You can activate several 1 2 3 4 5 6 7 8 dip-switches depending on the requested functions. NOTE Dip-switch “Extended push”...
-
Page 7: Notification Sound
NOTIFICATION SOUND When you press the push front there is a notification sound. Dip-switch 5: ON 1 2 3 4 5 6 7 8 DIP-SWITCH 6 Always set on OFF mode. Is not used. Available spot for future functionalities 1 2 3 4 5 6 7 8 RELAY 2 Switch to OFF mode. - Page 8 1200 ACCESSIBILITY FOR EVERYBODY Jarnvagsgatan 19, SE-543 50 Tibro ADDRESS +46 504 400 40 SWITCHBOARD prismatibro.se contact@prismatibro.se E-MAIL...