SIP to SIP Device Installation Overview The EdgeMarc 2900e device is designed for desktop, shelf, tray, wall, or rack installation. Observe the following guidelines when installing the system: Always verify that the AC power cord is disconnected from a power source prior to installation...
Page 3
(for example, use of power strips). The EdgeMarc 2900e feature two sets of three mounting holes on each side so the device can be reversibly mounted with the back facing out.
Page 4
SIP to SIP Device Installation Connecting the Power and Cables Rear Panel 1. Place EdgeMarc into install location either in a rack with PBX or on a shelf near PBX 2. Plug Power Cord into the port (circled in red) on back panel and plug other end of cord into an electrical outlet being careful to avoid pressing the Erase Button 3.
Need help?
Do you have a question about the EDGEMARC 2900e and is the answer not in the manual?
Questions and answers
What port is configured for DHCP?