Honda 08P00-TK8-100B Installation Instructions Manual page 2

Installing the Rear Splash Guards
1. Remove one bolt and three screws from the left rear
inner fender and rear bumper.
LEFT REAR 
INNER FENDER
FRONT
BOLT
2. Secure the left rear splash guard to the left rear inner
fender and rear bumper with one 5 x 25 mm self-
tapping screw, one bolt removed step in 1 and two
screws removed step in 1. While holding the splash
guard firmly against the fenderwell, tighten the self-
tapping screw, screws and bolt in the order

NOTE: Check for a gap between the splash guard
and the body. If a gap exists, loosen the screws and
repeat the above procedure.
LEFT REAR 
INNER FENDER
FRONT
2
BOLT
2 SCREWS
2 of 3
REAR
BUMPER
3 SCREWS
. 
REAR
BUMPER
3
4
1
5 x 25 mm 
SELF-TAPPING SCREW
3. Remove one bolt and two screws from the right rear
inner fender and rear bumper.
REAR
BUMPER
012905AB
4. Secure the right rear splash guard to the right rear
inner fender and rear bumper with one hook, one 5 x
25 mm self-tapping screw, one bolt removed step in
3 and one screw removed step in 3. While holding
the splash guard firmly against the fenderwell,
tighten the self-tapping screw, screw and bolt in the
order

NOTE: Check for a gap between the splash guard
and the body. If a gap exists, loosen the screws and
repeat the above procedure.
LEFT
REAR
RIGHT
SPLASH
REAR
GUARD
SPLASH
012906CB
GUARD
AII 49542 (1306)
RIGHT REAR 
INNER FENDER
BOLT
2 SCREWS
. 
RIGHT REAR 
REAR
INNER FENDER
BUMPER
2
3
1
HOOK
SCREW
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
FRONT
042701AY
FRONT
BOLT
5 x 25 mm 
SELF-TAPPING
SCREW
042702BY