Installing The Shaders On An Nx Module - Barco NX-4 Installation Manual

10.9 Installing the shaders on an NX module

Necessary parts
New shaders.
How to install the shaders on an NX module?
1. Softly press the new shader over the LED's. Use your bare fingers (not nails) to press the shader over the LED's. Make sure
that the shaders are correctly oriented.
Caution: Never push with a hard or sharp object onto the soft lens of the LED as this may cause damage to the LED. The
maximum allowed load upon the soft lens of the LED is 300 gram/LED.
Image 10-22
2. Check each shader for flatness. Use your finger nails to press upon the framework of the shader between the LED's (not upon
the LED's) to push the shader in its final position.
Note: Pay special attention that the shader is latched overall all LEDs. Check the bottom edge (E) of each shader.
E
Image 10-23
R59770279 NX FIXED 16/06/2008
10. SERVICING
81