Table of Contents
Advertisement
8. Remove the Viper collar from the packaging materials and loosen
the clamping bolt allowing the collar to open.
9. Fit the Viper seals into the Viper collar. Make certain that the
grease inlet holes on the seal and viper collar are aligned.
Note seals are sized to suit the wire rope as per the "Selection
guide".
10. Clamp the lubricator collar fitted with seals around the wire rope
to be lubricated, tightening the toggles.
• Face the collar so that the hydraulic coupling is at the
rope inlet end when the rope is being moved through
the collar.
• Locate the collar so that the optimum length of wire
rope can be lubricated in a single pass, this is typically
close to the winch drum.
11. Connect the high-pressure lubricant delivery hose to the Viper
Collar using the quick connect coupler.
Page | 14
Advertisement
Table of Contents
