Table of Contents
Advertisement
4.0 Viper Mini MKII Assembly Instructions
1. Remove all components from Viper aluminium carry case, unpack
from packing materials and lay out on a flat surface. Check all items
are present as per your purchase order.
2. Remove grease pump noting that the air inlet isolation valve,
air regulator is preassembled onto the pump.
• Connect site specific compressed air connector to
the air regulator.
o Standard Pump
o High Speed Pump
3. Remove lid from lubricant container and place follower plate
onto the top of the lubricant. Press down firmly until the
follower plate comes in contact with the lubricant.
• Note the Viper lubricator should only be used with high
quality wire rope lubricants with a consistency of
NLGI #00 to #2.
4. Fit the drum cover over the top of the lubricant container and
tighten the three securing screws until they contact the
container.
5. Clamp the grease pump handle onto the grease pump body and
tighten the two screws.
6. Slide the grease pump shaft into the opening of the drum cover
and the follower plate. Push the grease pump down into the
grease until it touches the base of the grease container.
7. Connect the high-pressure grease hose to the grease pump
outlet via the quick connect coupling.
o Standard Pump
o High Speed Pump
(refer assembly video on website)
Page | 13
Advertisement
Table of Contents
