Lincoln Electric K1655-9-LFA 4.1 Operator's Manual page 27

FUME EXTRACTION ARMS
MOUNTING
LFA 4.1-LC LOW CEILING
ARM
Components
K1655-13 – LFA 4.1-LC, 13FT EXTRACTION ARM
ITEM DES RIPTION
1 ARM BODY (2 SEPARATE PIECES)
2 HOSE SUPPORT
3 HOOD ASSEMBLY
4 FLEXIBLE HOSES
5 MOUNTING ASSEMBLY
6* INSTRUCTION MANUAL
7* LOOSE HARDWARE BAG
*NOT SHOWN
See Parts Page for Hardware Bag Contents
For wall mounting applications:
Install wall mounting brackets as detailed in the section titled
"INSTALLATION OF WALL MOUNTING BRACKETS" for Operator
Manual IM10320 SF2400 Stationary Fan.
MoUntinG tHe lfa 4.1-lc eXtraction arM on
tHe Wall bracKet
See Figure A.30 for steps 1-4
1. Cut through the upper and lower cable ties (Item A). The
cotter pin is not used for wall mount applications.
QTY
1
1
1
3
1
1
1
2. The mounting assembly of the arm comes in three pieces:
(See to Figure A.31)
• Metal rotating rod (Item A),
• red plastic ring (Item B),
• and metal spring collar pivot rod (Item C).
Mount the red plastic ring to the metal mounting assembly by
fitting the metal spring collarpivot rod through the hole in the
rotating rod, and snapping it into place on the U-shaped
indents on the red plastic ring. The lip of the ring should fit
securely against the top edge of the mounting assembly yet
rotate with the rod.
C
A-18
FIGURE A.30
B
A
FIGURE A.31
INSTALLATION
A
B