Installation; Electric Shock Can Kill; Select Suitable Location - Lincoln Electric K1655-9-LFA 4.1 Operator's Manual

FUME EXTRACTION ARMS
Read this entire installation section before you
start installation.

INSTALLATION

WARNING

ELECTRIC SHOCK CAN KILL.

• Only qualified personnel should perform
this installation.
• Turn the input power OFF and unplug
the machine from the receptacle before
working on this equipment.
• Insulate yourself from the work and ground.
• Always connect the machine to a power supply
grounded according to the National Electrical Code and
local codes.
MOVING PARTS can injure.
• Do not operate with covers open or
filter removed.
• Keep away from moving parts.
CAUTION
TIPPING Hazard
Unit is to be used on flat surface only.
The extraction arm must be fastened in an upright and
folded position during transport of the unit.
Only qualified personnel should install, use or
service this equipment.

select sUitable location

• Inspect the product and check it for damage. Verify the
functioning of the safety features.
• During use, always use Personal Protective Equipment (PPE)
to avoid injury. This also applies for persons who enter the
work area.
• Check the working environment. Do not allow unauthorized
persons to enter the working environment.
• Protect the product against water and humidity.
• Make sure the room is always sufficiently ventilated; this
applies especially to confined spaces.
WARNING
The installer is responsible for following local
safety codes and regulations.
Before drilling, verify locations of existing gas, water, or
electrical conduits.
For mounting compatibility see "EXTRACTION
ARM MOUNTING COMPATIBILITY" table
located on page A-1.
For wall mounting applications:
Install wall mounting brackets as detailed in the section titled
"INSTALLATION OF WALL MOUNTING BRACKETS" for Operator
Manual IM10320 SF2400 Stationary Fan.
• LTA 2.0-CW includes mount assembly. See wall
mounting instruction on page A-11.
• FOR LAMP KIT APPLICATIONS:
Install the wiring for the lamp kit as detailed in the
section titled "Installing the Lamp Kit" for operator
manual IM10366 Lamp Kit for Wall Mounted Systems
For Mobiflex mounting applications:
Install the base swivel mount on top of the machine as detailed in
the section titled "INSTALLATION" for Operator Manual IM10335
Mobiflex 200 & 200 HE.
Tools and requirements
The following tools are needed to mount and maintain extraction
arms.
• 9/16" wrench and socket
• 1/2" wrench and socket
• 7/16" wrench and socket
• Oil lubricant
• Grease lubricant
• Utility knife
• PPE - safety glasses and gloves
• 1/8" hex bit
A-4
INSTALLATION