Craftsman 917.28853 Operator's Manual page 24

TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive bett may be replaced
without tools, Park the tractor on level sur-
face, Engage parking brake.
BELT REMOVAL -
1. Remove mower from tractor (See "TO
REMOVE MOWER" in this section of
manual).
2. Work belt off both mandrel pulleys and
idler pulleys,
3. Pull belt away from mower.
BELT INSTALLATION -
1. Work belt around both mandrel pulleys
and idler pulleys
2. Ensure belt is in all pulley grooves and
inside all belt guides,
& Install mower (See "To Install Mower" in
this section of this manua0.
Mandrel Idler
Pulleys
Mandrel
BELT INSTALLATION -
1, installnew belt from tractorrear to front,
over the steering plate (F) and above
clutch brake pedal shaft (G).
2. Pull belt toward front of tractor and roll
belt onto engine pulley (E).
3, Pull belt toward rear of tractor, Carefully
work belt down around transmission
cooling fan and onto the input pulley (D),
Be sure belt is inside the belt keeper.
4. Install belt on centerspan idler (C).
5. tnstali belt through stationary idler (A)
and clutching idler (B),
6, Ensure belt is in all pulley grooves and
inside all belt guides and keepers,
7. Install mower (See "TO INSTALL MOW-
ER" in this section of manual).
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
BELT REMOVAL -
...... 1,-'Remove mower (See. _'TO-REMOVE .........
MOWER" in this section of manual).
NOTE: Observe entire motion drive belt
and position of all belt guides and keepers,
2. Remove beltfrom statJonaryidler (A) and
clutching idler (B).
3. Remove belt from centerspan idler (C).
6. Pull belt slack toward rear of tractor,
Carefully remove belt upwards from
transmission input pulley and over cool-
ing fan blades (D).
4, Remove belt downward from engine
pulley (E),
5. Slide belt toward rear of tractor, off the
steering plate (F)and remove from tractor.
FRONT WHEEL TOE-IN!CAMBER
"your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe4n and camber are not
adjustable. If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
24