Meyer MDII Installation Instructions

PARTS & INSTALLATION INSTRUCTIONS
2017 & Later FORD F250 thru F550
End user must be given this instruction sheet prior to delievery of this Snow Plow.
In conjunction with FMVSS (Federal Motor Vehicle Safety Standards) and OEM (Original Equipment Manufacturer) guidelines,
Meyer Products has designed this plow package with the following guidelines:
Installation of a snowplow may effect your new vehicle warranty.
For more information consult your Vehicle Owner's Manual / Vehicle Dealer.
The vehicle must not be operated when overloaded. In all cases, the loaded vehicle weight, including the entire
snowplow system, all aftermarket accessories, driver, passenger, options, nominal fluid levels, and cargo must not
exceed the front/rear Gross Axle Weight Rating (GAWR), and total Gross Vehicle Weight Rating (GVWR). These
weights ratings are specified on the safety compliance certification label on the driver's side door opening. The use
of rear ballast weight may be required to prevent exceeding the front GAWR.
According to the NHTSA (National Highway Traffic Safety Administration) new and untitled vehicles need to be verified by the installer that
snowplow and ballast (if needed) do no exceed the front/rear GAWR and total GVWR.
Read the Meyer Owner's Manual before operating or servicing a snowplow.
EXPLICITLY.
SAFETY PRECAUTIONS should be used when Hydraulic Unit is in OPERATION and plow is in a RAISED
position. Lower plow to ground when vehicle is PARKED in case of hydraulic failure.
Check contents against the parts list to determine all are correct and included, and also to familiarize yourself with them.
Warranty does not apply to a Meyer or Diamond product which has been negligently or improperly assembled or
installed.
CAUTION: To avoid harm to vehicles electrical system always disconnect battery before beginning installation.
DO NOT BURN holes or WELD vehicle frame. This may cause frame failure.
OVERHAUL and SERVICE INFORMATION are covered on separate instructions.
Meyer Products LLC reserves the right, under its continuing product improvement program, to change construction or design details,
specifications and prices without notice or without incurring any obligation.
Meyer Products LLC
18513 Euclid Ave. • Cleveland, Ohio 44112-1084
Phone 486-1313 (Area Code 216)
www.meyerproducts.com• email info@meyerproducts.com
© 2016 Printed in the U.S.A.
MDII™and EZ MOUNT PLUS™
SNOW PLOW MOUNTING 17195
4x4 MODELS
Snow Plow Preparation Package 86M
SAFETY DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
WARNING Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION Indicates an potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
CAUTION used without the safety alert symbol indicates a potentially hazardous situation
which, if not avoided, will result in property damage.
IMPORTANT NOTICE
GENERAL INFORMATION
FOLLOW THESE INSTRUCTIONS
Meyer Products LLC
6 Angell Lane • Damariscotta, ME 04543-4507
Phone 563-2227(Area Code 207)
www.meyerproducts.com• email info@meyerproducts.com
Form 1-1151
July 2016